Channel Strip Displays - Yamaha DM 2000 Owner's Manual

Channel Strip Displays

C H 0 1
Selected Channel
Fader Touch Sense
Routing Indicators
EQ, Insert, Delay, Comp & Gate Indicators
Encoder Displays
Operation of the Encoder displays depends on the parameter assigned to the
Encoders, as follows.
Pan Mode
Hard left
( indicates center position)
Aux/Mtrx Mode
Minimum (–∞)
( indicates nominal position)
Attenuator Parameter & Surr LFE Level
Minimum (–96 dB)
( indicates nominal position)
The fluorescent channel strip displays graphically display the value of the
Input or Output Channel parameter currently assigned to the Encoders,
routing settings, and the on/off status of the EQ, Insert, Delay, Comp,
and Gate functions. They also display the Long and Short channel names
and indicate the currently selected channel. You can adjust their bright-
ness by using the Channel Strip Display Brightness preference on
page 236.
The border of the currently selected channel's channel strip display lights
up like this.
When fader knobs are touched, the corresponding Touch Sense indica-
tors light up like this.
These indicators show to which Output Channels an Input Channel is
being routed: 1 through 8 being the Bus Outs, "S" being the Stereo Out,
and "D," the Direct Out.
These indicators show whether a channel's EQ, Insert, Delay, Comp, and
Gate functions are on or off.
Other position
Other position
Other position
Channel Strip Displays
Center
( indicates at center)
Nominal
( indicates at nominal)
Nominal
( indicates at nominal)
DM2000—Owner's Manual
39
Hard right
Maximum
Maximum