Yamaha DM 2000 Owner's Manual page 213

Control Surface Operation with the Pro Tools Remote Layer
[12] (CTRL/CLUTCH) & [13] (Command-ALT/FINE) buttons
These buttons are used in conjunction with other buttons to modify function operation.
They correspond to the Control and Command modifier keys found on Macintosh key-
boards.
[14] (MONITOR) button
This button is used to display the monitor mode currently selected in the Pro Tools Opera-
tions menu. When the monitor mode is set to "Auto Input Monitor," "Auto" is displayed.
When it's set to "Input Only Monitor," "Inpt" is displayed. Aux Input channels always dis-
play "AUX." Master fader channels always display "Mstr." And MIDI Tracks always display
"MIDI."
[15] (UNDO) button
This button is used to undo and redo the last operation. Its indicator lights up when the last
operation can be undone, and it flashes when the last operation can be redone.
[16] (SAVE)
This button is used to save the current session (same as Save Session command in the File
menu). Its indicator lights up when there are unsaved changes, and goes out when there are
no unsaved changes. When pressed, the indicator flashes and you can press it again to go
ahead and save the current session, or press [ESC] to cancel.
LOCATOR Section
[DISPLAY] (MEM-LOC) button
This button is used to open and close the Memory Locations window.
LOCATE MEMORY [1–8] buttons
These buttons perform the same transport-related functions as the 1–8 number keys on a
Macintosh keyboard. If you set the Numeric keypad Mode in Pro Tools to "Classic" (Setups
menu, Preferences), these buttons can be used to directly locate markers 1–8.
[AUDITION] button
This button is used in conjunction with the [PRE], [IN], [OUT], and [POST] buttons for
auditioning. Its indicator lights up while auditioning is on and operation is as follows:
• Press the [PRE] button to audition the section between the pre-roll point and the in point
of the selected region.
• Press the [IN] button to audition from the in point of the selected region, continuing for
the specified pre-roll time.
• Press the [OUT] button to audition the section before the out point of the selected region.
The length of the section is determined by the post-roll time.
LOCATOR
LOCATE MEMORY
DISPLAY (MEM-LOC)
1 2 3 4
AUDITION PRE IN OUT POST
RETURN END ONLINE LOOP QUICK
TO ZERO PUNCH
5 6 7 8
DM2000—Owner's Manual
199