Setting Input Channel Levels; Grouping Input Channel Faders - Yamaha DM 2000 Owner's Manual

74
Chapter 7—Input Channels

Setting Input Channel Levels

Input Channel levels can be set as follows.
Use the LAYER buttons to select the Input Channel Layers.
1
2 Press the FADER MODE [FADER] button to select Fader mode.
Use the faders to set the Input Channel levels.
3
Refer to the legend on the left side of the faders when setting Input Channel levels.
Fader positions can be viewed on the Fader View pages. See "Viewing Channel
Fader Settings" on page 125 for more information.

Grouping Input Channel Faders

Input Channel faders can be grouped, allowing you to control the level of several
Input Channels simultaneously. There are eight Input Channel Fader groups: A, B, C, D, E,
F, G, and H.
1 Use the DISPLAY ACCESS [GROUP] button to locate the Input Channel Fader
Group pages.
The Fader Group parameters for the 96 Input Channels are divided between two pages. The
Input Channel 1–48 Fader Group page is shown below. The layout of the other page is the
same.
Use the LAYER buttons to select the Input Channel Layers.
2
The corresponding Fader Group page and group row is selected as each Input Channel
Layer is selected.
Use the Up/Down cursor buttons to select Fader groups A–H.
3
The selected group is highlighted by a flashing cursor box.
Use the [SEL] buttons to add and remove faders to and from the selected
4
group.
When an Input Channel is added to a group, its [SEL] button indicator lights up.
ENABLE: These buttons are used to enable and disable the groups.
You can temporarily disable a Fader group in order to make adjustments to individual fad-
ers by operating the desired channel fader while holding down its [SEL] button.
Fader groups are active only in Fader mode (i.e., when the FADER MODE [FADER] button
indicator is on). See "Selecting Fader Modes" on page 44 for more information.
DM2000—Owner's Manual
10 0
5 5
0 10
5 15
10 20
15 30
20 40
30 50
40 60
50 70