Yamaha DM 2000 Owner's Manual page 301

AUTO PAN 5.1
Six input, six output autopanner for 5.1 surround. You can reset to the pan position speci-
fied by the OFFSET parameter by pressing the RESET button.
Parameter Range
OFF, HOLD, INPUT,
SOURCE
MIDI
TRIG. LVL
–60 to 0 dB
TRG MASK
0–1000 ms
TIME
0.1 s–10.0 s
SPEED
0.05 Hz–40.00 Hz
DIR.
Turn L, Turn R
OFFSET
–180 to +180 degrees
THRU,
HPF
21.2 Hz–8.00 kHz
50.0 Hz–16.0 kHz,
LPF
THRU
CHORUS 5.1
Six input, six output chorus for 5.1 surround.
Parameter Range
FREQ.
0.05–40.00 Hz
AM DEPTH
0–100%
PM DEPTH
0–100%
MOD. DLY
0.0–400.0 ms
WAVE
Sine, Tri
THRU,
HPF
21.2 Hz–8.00 kHz
50.0 Hz–16.0 kHz,
LPF
THRU
SYNC
OFF/ON
NOTE 1
1.
Effects Parameters
Description
When set to OFF, the TRIGGER button is used to start auto-
pan. When set to HOLD, autopan runs continuously. When
set to INPUT, the input signal triggers autopan. When set to
MIDI, a MIDI Note On message can be used to trigger auto-
pan.
Input trigger level (i.e., the signal level required to trigger
panning when SOURCE set to INPUT)
Trigger Mask specifies the time from when a trigger is
received until the next trigger will be accepted.
The time after which autopan starts once it's been triggered
Autopan speed
Autopan direction
Pan offset
High-pass filter cutoff frequency
Low-pass filter cutoff frequency
Description
Modulation speed
Amplitude modulation depth
Pitch modulation depth
Modulation delay time
Modulation waveform
High-pass filter cutoff frequency
Low-pass filter cutoff frequency
Tempo parameter sync on/off
Used in conjunction with TEMPO to determine FREQ.
287
DM2000—Owner's Manual