Yamaha DM 2000 Owner's Manual page 291

REV+FLANGE
One input, two output reverb and flanger effects in parallel.
Parameter Range
INI. DLY
0.0–500.0 ms
REV TIME
0.3–99.0 s
HI. RATIO
0.1–1.0
DIFF.
0–10
DENSITY
0–100%
THRU,
HPF
21.2 Hz–8.00 kHz
50.0 Hz–16.0 kHz,
LPF
THRU
REV/FLG
0–100%
FREQ.
0.05–40.00 Hz
DEPTH
0–100%
MOD. DLY
0.0–500.0 ms
FB. GAIN
–99 to +99%
WAVE
Sine, Tri
SYNC
OFF/ON
NOTE 1
1.
REV->FLANGE
One input, two output reverb and flanger effects in series.
Parameter Range
INI. DLY
0.0–500.0 ms
REV TIME
0.3–99.0 s
HI. RATIO
0.1–1.0
DIFF.
0–10
DENSITY
0–100%
THRU,
HPF
21.2 Hz–8.00 kHz
50.0 Hz–16.0 kHz,
LPF
THRU
REV BAL.
0–100%
FREQ.
0.05–40.00 Hz
DEPTH
0–100%
MOD. DLY
0.0–500.0 ms
FB. GAIN
–99 to +99%
WAVE
Sine, Tri
SYNC
OFF/ON
NOTE 1
1.
Effects Parameters
Description
Initial delay before reverb begins
Reverb time
High-frequency reverb time ratio
Spread
Reverb density
High-pass filter cutoff frequency
Low-pass filter cutoff frequency
Reverb and flange balance (0% = all reverb, 100% = all
flange)
Modulation speed
Modulation depth
Modulation delay time
Feedback gain (plus values for normal-phase feedback,
minus values for reverse-phase feedback)
Modulation waveform
Tempo parameter sync on/off
Used in conjunction with TEMPO to determine FREQ.
Description
Initial delay before reverb begins
Reverb time
High-frequency reverb time ratio
Spread
Reverb density
High-pass filter cutoff frequency
Low-pass filter cutoff frequency
Reverb and flanged reverb balance (0% = all flanged reverb,
100% = all reverb)
Modulation speed
Modulation depth
Modulation delay time
Feedback gain (plus values for normal-phase feedback,
minus values for reverse-phase feedback)
Modulation waveform
Tempo parameter sync on/off
Used in conjunction with TEMPO to determine FREQ.
277
DM2000—Owner's Manual