Stereo Out; Control Room Monitor Outs; Studio Monitor Outs; Omni Outs - Yamaha DM 2000 Owner's Manual

AD Inserts
AD Inputs feature switchable analog inserts with individual balanced 1/4-inch
TRS phone jacks for the send and return signals. They are wired:
sleeve–ground, ring–cold, tip–hot. The nominal signal level for both connec-
tors is +4 dB.
AD Input inserts can be turned on and off individually by using the INSERT
OFF
ON
ON/OFF switches, so you don't have to disconnect your external equipment in
INSERT
order to remove an insert.

Stereo Out

See page 82 for information on the Stereo Out outputs.

Control Room Monitor Outs

See page 132 for information on the Control Room Monitor outputs.

Studio Monitor Outs

See page 133 for information on the Studio Monitor outputs.

Omni Outs

The DM2000 features assignable Omni Outs on balanced 1/4-inch TRS phone jacks. Omni
Outs can be patched to Bus Outs, Aux Sends, Matrix Sends, the Stereo Out, Input or Output
Channel Insert Outs, or Surround Monitor Channels (see page 64). In addition, Input
Channel Direct Outs can be patched to the Omni Outs (see page 65).
The maximum output level of each OMNI OUT can be set internally to either +4 dB
(–10 dB operating level) or +18 dB (+4 dB operating level). Contact your dealer for further
details.

2TR Analog INs

The DM2000 features two sets of 2-track analog inputs: 2TR IN ANALOG 1
+4 dB (BAL) uses balanced 1/4-inch TRS phone jacks. 2TR IN ANALOG 2
–10 dBV (UNBAL) uses unbalanced phono jacks. These inputs can be moni-
tored via the Control Room monitors by pressing the CONTROL ROOM
[2TR A1] and [2TR A2] buttons. They can be patched to Input Channels (see
page 61), Input Channel Insert Ins (see page 62), or Output Channel Insert Ins
(see page 64).
49
Stereo Out
DM2000—Owner's Manual