Yamaha DM 2000 Owner's Manual page 32

18
Chapter 2—Control Surface & Rear Panel
LAYER
A
1–24, 25–48, 49–72 & 73–96 buttons
These buttons select the Input Channel Layers, which determine which Input Channels are
controlled by the channel strips. The LAYER button indicator for the currently selected
Layer lights up. See "Selecting Layers" on page 42 for more information.
B
MASTER button
This button selects the Master Layer, from which the channel strips control Bus Outs, Aux
Sends, and Matrix Sends. Its indicator lights up when the Master Layer is selected. See
"Selecting Layers" on page 42 for more information.
C
REMOTE 1–4 buttons
These buttons select the Remote Layers, which can be used to control external devices,
including DAWs. See "About Remote Layers" on page 217 for more information. The
LAYER button indicator for the currently selected Remote Layer lights up. See "Selecting
Layers" on page 42 for more information.
STEREO
A
STEREO
This button is used exclusively to set Automix recording and playback for the Stereo
1
AUTO Out. Its indicator lights up orange in Record-Ready mode, red while recording, and
2
green during playback. See "Channel Strip [AUTO] Buttons" on page 169 for more
SEL
information.
3
ON
B
The Stereo Out [SEL] button is used exclusively to select the Stereo Out for editing with
the SELECTED CHANNEL section. Its indicator lights up when the Stereo Out is
selected. Each time it's pressed, the selection toggles between the Stereo Out's left and
right channels. See "Selecting Channels" on page 43 for more information. It can also
0
be used to add and remove the Stereo Out to and from EQ, Comp, Fader, and Mute
5
groups.
10
C
15
4
This button is used exclusively to mute the Stereo Out. Its indicator lights up when the
20
Stereo Out is on. See "Muting the Stereo Out (ON/OFF)" on page 83 for more informa-
30
tion.
40
D
50
This 100 mm touch-sensitive motorized fader is used exclusively to adjust the level of
60
70
the Stereo Out. See "Setting the Stereo Out Level" on page 83 for more information. It
can be grouped with other Output Channel faders for simultaneous operation. See
"Grouping Output Channel Faders" on page 122 for more information. It can also be
STEREO
used to select the Stereo Out, see "Auto Channel Select & Touch Sense Select" on
page 44, or to punch the Stereo Out in and out during Automix recording. See "Punch-
ing In & Out Individual Parameters" on page 175 for more information.
DM2000—Owner's Manual
1
2
AUTO button
SEL button
ON button
Fader
LAYER
1
1 24 REMOTE
3
2
25 48 REMOTE
3
REMOTE
49 72
4
REMOTE
73 96
MASTER