Table of Contents
Advertisement
Specifications
Input characteristics
Connector in
console
Actual load | For use with
impedance
nominal
Input
terminals
Input level 8
Sensitivity `!
|
Nominal
Max. before clip
EN
-80 dB (0.078 mV) | -60 dB (0.775 mV)
50-600 ๑
EN
10 ๒ ๐
mics 8 | -36 dB (12.3 mV) | -16dB (123 mV) | +4 dB (1.23 V)
EI
| 92468(1237 |
XLR-3-31 type 2
or
phone jack (TRS)
*3
MIC INPUT
600 Q lines
-16 dB (123 mV)
+4 dB (1.23 V)
+24 dB (12.3 V
SOURCE INPUT A,B
—40 dB (7.75 mV) | -20 dB (77.5 mV)
0 dB (775 mV)
600 Q lines
RCA pin jack 5
10 kQ
10 kQ
600 Q lines
Dsub 9PIN
0 dB (775 mV)
+20 dB (7.75 V)
(female) 7
— 6 dB (388 mV)
0 dB (775 mV)
+20 dB (7.75 V)
phone jack '6
*1 Sensitivity is the lowest level that will produce an output of +4 dB(1.23 V) or the nominal output level when the unit is set to maximum gain. (All faders and level
controls are maximum position.)
*2 XLR type connectors are balanced. (1=GND, 2=HOT, 3=COLD / CH 1, 2, 3, 4)
*3 MIC INPUT phone jacks are balanced, but can be used as unbalanced. (Tip =HOT, Ring=COLD, Sleeve=GND / CH 1, 2, 5, 6,)
*4 MIC INPUT PADs are available only in CH3, 4, 5, 6 for wireless microphones and electronic instruments.
*5
All pin jacks are unbalanced.
*6
All phone jacks except MIC INPUTs are unbalanced.
*7 Dsub 9pin connector includes mic 4 effect sub inputs and DC power supply.
*8 In these specifications, when dB represents a specific voltage, O dB is referenced to 0.775 volts RMS.
RCA pin jack 5
phone jack "®
phone jack "8
.3V)
CH1-CH3 [L,R]
-16 dB (123mV) | +4dB(1.23V)
| +24dB (12.3 V)
. 3
V)
Output characteristics
Output level "4
*1 XLR type connectors are balanced. (1=GND, 2=HOT, 3=COLD / CH 1, 2, 3, 4)
*2 All phone jacks are unbalanced
*3 All pin jacks are unbalanced
*4 | ท these specifications, when dB represents a specific voltage, O dB is referenced to 0.775 volts RMS.
Connecter in
console
For use with
nominal
Actual source
impedance
Output terminals
18
Advertisement
Table of Contents
