Oki MB472dn User Manual page 1076

Setting This Machine
To enable IPSec, you must set this machine by using the Web page in advance.
Note
If IPsec is set to this machine and the host, IPSec communication is established. If IPSec is not set to the host, IPSec
communication is not established.
Take notes of the values specified in this procedure not to forget these values. These values are necessary when setting IPSec on
a computer.
1.
Open the Web page of this machine.
About the IP address of this machine
Setting an IP Address from the Operator Panel on This Machine
How to log in to the Web page
About the Web Page of This Machine
2.
Log in as the administrator.
How to log in as the administrator
About the Web Page of This Machine
3.
Select [Admin Setup].
4.
Select [Network] > [Security] > [IPSec].
5.
Specify detailed settings by following the on-screen instructions.
Memo
You must enable either [AH] or [ESP] in [Phase2 Proposal] setting.
To use a Scan To function, you must select the [Initiator] check box.
6.
Click [Submit].
The new settings take effect when the network function of this machine restarts.
Note
If you cannot set up IPSec due to inconsistency of specified parameters, you may not be able to access the Web page. In such a
case, disable the IPSec from the operator panel of this machine or initialize the network settings.
Topics
Proceed to setting a computer.
Setting a Computer
1075