Adjusting The Density When Faxing - Oki MB492dn User Manual

Adjusting the Density When Faxing

This section describes how to change the default setting of the density when faxing. You can adjust the density in seven levels.
1.
Press [Device Settings] on the touch panel.
2.
Press [Admin Setup].
3.
Enter the administrator password.
The factory default password is "aaaaaa".
4.
Press [OK].
5.
Press [Fax Setup].
6.
Press [Default Settings].
7.
Press [Density].
8.
Select a value.
9.
Press [Back] until the home screen is displayed.
Memo
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-2], or
[-3] (lightest).
810