Removing Punch Waste - Canon iR 3300 Reference Manual

5 5 5 5
Connect the finisher to the main unit. Connect the finisher to the main unit.
Connect the finisher to the main unit. Connect the finisher to the main unit.
CAUTION CAUTION
CAUTION CAUTION
• • • •
When returning the finisher to its original position, be careful not to get your fingers caught, as When returning the finisher to its original position, be careful not to get your fingers caught, as When returning the finisher to its original position, be careful not to get your fingers caught, as When returning the finisher to its original position, be careful not to get your fingers caught, as
this may result in personal injury. this may result in personal injury. this may result in personal injury. this may result in personal injury.
6 6 6 6
Follow the instructions on the touch panel display. Follow the instructions on the touch panel display.
Follow the instructions on the touch panel display. Follow the instructions on the touch panel display.
NOTE
• • • •
For details of the screen indicating how to clear the paper jam, see 'Screen Shown When There Is a
Paper Jam,' on p. 6-2.
7 7 7 7

Removing Punch Waste

Removing Punch Waste

Removing Punch Waste Removing Punch Waste
When the punch waste tray becomes full, a screen similar to the one shown below appears on
the touch panel display. Follow the procedure described below, to remove the punch waste.
NOTE
• • • •
This procedure is only required when the Puncher Unit-J1 and Puncher Unit-G1 are attached.
7-70 7-70 7-70 7-70 Saddle Finisher-G1/Puncher Unit-J1/Puncher Unit-G1