Laser scanning unit (LSU) removal
1
Remove the right cover. See
2
Remove the left cover. See
3
Remove the rear door and cover. See
4
Remove the top cover. See
5
Remove the cooling fan. See
6
Disconnect the cable JGLV1 or J6 from the controller board.
7
Before loosening the screws securing the LSU, use a sharp pencil or a small, flat-blade screwdriver to mark
the location of the LSU on the printer frame. This will be helpful in positioning the new LSU.
8
Disconnect the two cables (A) from the LSU.
"Right cover removal" on page
"Left cover removal" on page
"Rear door and cover removal" on page
"Top cover removal" on page
"Cooling fan removal" on page
Parts removal
264
209.
194.
256.
263.
209.
4514-2xx