Power Failure Detection - NEC PD17062 Datasheet

14.6 POWER FAILURE DETECTION

Power failure detection is used to judge whether the device is reset by turning on V
shown in Fig. 14-9.
Since the contents of the data memory, output ports, etc. become "undefined" when V
are initialized by power failure detection.
14.6.1 Power Failure Detection Circuit
As shown in Fig. 14-1, the power failure detection circuit consists of a voltage detection circuit and timer
carry disable FF that is reset by the output (power-on clear signal) of the voltage detection circuit, and timer
carry FF.
The timer carry disable FF is set to 1 by the power-on clear signal and is reset to 0 when a BTM0CY flag
(address 17H, bit b ) read instruction is executed.
0
When the timer carry disable FF is set to 1, the BTM0CY flag is not set to 1.
That is, when the power-on clear signal is output (at power-on reset), the program starts in the state in which
the BTM0CY flag is reset and the setting disabled state is set until a BTM0CY read instruction is executed
thereafter.
Once a BTM0CY read instruction is executed, the BTM0CY flag is set at each rising edge of the timer carry
FF set pulse thereafter. When reset is applied to the device, the contents of the BTM0CY flag are monitored.
If the BTM0CY flag has been reset to 0, power-on reset (power failure) is judged and if the BTM0CY flag has
been set to 1, CE reset (no power failure) is judged.
Since the voltage that can detect a power failure is the same as the voltage applied by power-on reset, V
becomes 3.5 V at clock oscillation and 2.2 V at clock-stop.
Fig. 14-10 shows the BTM0CY flag state transition.
Fig. 14-11 shows timing chart and BTM0CY flag operation specified in Fig. 14-10.
184
Fig. 14-9 Power Failure Detection Flowchart
Program start
Power
failure detect-
No power failure Power failure
ion
Data memory,
output port, etc.
initialization
PD17062
or by the CE pin, as
DD
is turned on, they
DD
DD