Table of Contents
Advertisement
8
Power Supply and Power Cord Use
Disconnect the power cord(s) before installing or removing the product in/from the server.
Make sure to power off the server and disconnect the power cord(s) from a power outlet before
installing/removing the product in/from the server, or connecting with the peripheral devices. All voltage is
removed only when the power cords are unplugged.
Do not use any damaged cable.
Make sure the cable condition before connection. Using the damaged connector, bent connector pin, or
dirty connector may cause a fire due to short-circuit.
Do not hold the power plug with a wet hand.
Do not disconnect/connect the plug while your hands are wet. Failure to follow this warning may cause
an electric shock.
Do not pull the cable when disconnecting the power cord.
When disconnecting the power cord from the server, hold the plug and pull it straight out. Pulling the cord
out by the cable portion could damage the cable to result in an electrical shock hazard or a fire.
CAUTION
Advertisement
Table of Contents
