Table of Contents
Advertisement
4
Do not enter any characters here (if you do, you can't program a batch trans-
mission into this key). Instead, only press
P07:Fax Number
_
Note: If you accidentally enter any characters here, press
times as needed to erase all of them before you proceed to step 5.
Note: If this key already holds a batch transmission, skip to step 6.
5
Press
COMMUNICATION OPTIONS
Batch Tx
Enter Box No.
6
Use the numeric keypad to enter the one-digit identifier for the batch box you
wish to assign to this one-touch key. Here, we've entered 5:
Batch Tx
Enter Box No.
Note: To change an identifier already entered, press
Then re-enter until the entry is just as you want it.
7
Press
.
ENTER
8
The
now displays the next programmable one-touch key.
LCD
If you do not wish to enter or change any other key's programming, press
to return your machine to its usual standby mode.
If you do wish to enter or change this key's programming, go back to step 3.
If you wish to enter or change another key's programming, go back to step 2.
Programmable one-touch fax dialing
To dial a fax call using a programmable one-touch number:
1
Insert the document.
2
Adjust resolution and contrast if necessary.
3
Toggle between transmission from the feeder or from memory if necessary, by
pressing
.
MEMORY TRANSMIT
4
Press the programmable one-touch key in which you've stored the number.
Your fax will perform the operation either now or at whatever other time you set.
Note: To review each available operation's details, please review its appropriate
instructions. See page 2.36 for a list of where you may find each operation.
and then proceed to step 5.
ENTER
CANCEL
five times and then press
. The
ENTER
_
5_
to erase it.
CANCEL
If you programmed this key to delay its operation, the
** Reserved **
A4
However, if you programmed this key to perform the operation immediately after
the keypress, the
as many
9-1-972-555-4335
A4
shows:
LCD
Erasing a programmable one-touch key
1
Press /
PROGRAM
Select Program No.
P01:Delayed
If
01 is the key you want to erase, skip to step 3. (However, our examples
P
from here will say "
2
Press the programmable one-touch key you want to erase. Here, we've
selected
10:
P
Select Program No.
P10:Polling
STOP
3
If you change your mind and wish to erase a different programmable one-
touch key, just press that key before going on step 4.
4
Press
ENTER
Erase P One-Touch
Check Program/Enter
Important: If you want to quit without erasing the programmable one-
5
Press
ENTER
Erase P One-Touch
**
To erase another programmable one-touch key, repeat steps 2–5. Or press
return to standby mode.
Memory 95%
will show the number:
LCD
Normal
,
, 2,
. The
shows something like:
C
ENTER
LCD
10" rather than "
01.")
P
P
. The
shows:
LCD
touch key you've selected, press /
return to step 2.
to erase the number.
Complete
**
Beyond the basics
will show:
LCD
. The fax will
PROGRAM
to
STOP
2.43
Advertisement
Table of Contents
