Configuring Ipv6 Settings For The Scanner; Installing The Ipv6 Function; Checking The System Version; Enabling The Ipv6 Function - Fujitsu N7100 Operator's Manual

G.2 Configuring IPv6 Settings for the Scanner
G.2.1 Installing the IPv6 Function
Install the IPv6 function in the following procedure:

■ Checking the System Version

1. An administrator checks that the system version of the scanner is
"ns001 01.07.01.xxxx" or later via the Admin Tool or the touch panel.
If the system version is old (lower than "ns001 01.07.01.xxxx"), update the system
via the Admin Tool.
For details about how to check the system version, refer to
System Status" (page
For details about how to update the scanner, refer to
Scanner's System Software" (page

■ Enabling the IPv6 Function

1. An administrator logs in to the scanner via the Admin Tool or the touch
panel.
For details, refer to
2. When using the touch panel, select [Advanced] for the setting mode on
the [Admin Menu] window.
For details, refer to
3. On the [Network Advanced Settings] window under [Network Settings],
set the IPv6 function to [On].
For details, refer to

■ Configuring an IPv6 Communication Environment

1. An administrator logs in to the scanner via the Admin Tool or the touch
panel.
For details, refer to
2. Configure the network settings.
3. After you have configured all items, press the [Logout] button.
G.2 Configuring IPv6 Settings for the Scanner
160).
175).
"4.2 Administrator Login" (page
"4.3.1 Configuring the Setting Mode" (page
"4.7.7 Configuring Network Advanced Settings" (page
"4.2 Administrator Login" (page
458
"4.15.1 Viewing the
"4.17.1 Updating the
72).
77).
72).
108).