Connecting The Serial Interface Cable; Verifying Serial Parameter Settings - Fujitsu PRINTPARTNER User Manual

Connecting the Printer to Your Computer
Insert
connector
Secure
holding screws
1-18

Connecting the Serial Interface Cable

To connect to the serial interface port, you need a cable correctly
wired for this printer and your computer. The cable must also have
the proper connectors. Your dealer or technical support person can
supply you with the proper cable.
The serial interface of this printer requires a null-modem cable with a
male D-SUB 9-pin connector at the printer side. Refer to your
computer documentation for the type of connector required by its
serial port.
Caution:
Be sure that the printer is turned off before connecting the interface
cable.
Do not touch any connector contacts to avoid possible electrostatic
damage to the printer.

Verifying Serial Parameter Settings

Next, you must make sure the serial parameter settings are the same
between the computer and the printer. Consult your computer and
software documentation to determine the settings your computer
uses. Then compare these to the printer's settings in the following
table.
To make the connection,
plug the cable connector
into the serial interface port
at the back right of the
printer. Secure the
connector by tightening the
screws in the connector
hood. Plug the other
connector into your
computer's serial port.
Consult your computer
documentation if you need
help.
User's Manual