Scanner Cannot Be Turned On; Scanner Does Not Start Up - Fujitsu N7100 Operator's Manual

" The status window with the message "Printing scan data on xxx"remains or is slow."

(page 393)
" An error occurs when installing an Admin Tool." (page 393)

" When a fax is sent, the screen freezes on the scanning window." (page 393)


■ Scanner Cannot Be Turned On

Scanner cannot be turned on.
■ Check item
Has the power button been pressed?
■ Action
Press the power button.
■ Check item
Are the AC cable and AC adapter properly connected to the scanner?
■ Action
 Connect the AC cable and the AC adapter.
 Disconnect the AC cable from the scanner to turn off the scanner, and connect the AC cable
again. After turning the power off, wait for at least 10 seconds before turning the power back
on again.
If the problem persists even after taking the above mentioned actions, contact your FUJITSU
scanner dealer or an authorized FUJITSU scanner service provider.

■ Scanner Does Not Start Up

The "The last attempt to restart ..." message is shown on the window
and the scanner does not start up.
■ Check item
After turning the scanner on, was the power turned off immediately?
■ Action
 Press the power button.
 Disconnect the AC cable from the scanner to turn off the scanner, and connect the AC cable
again. After turning the power off, wait for at least 10 seconds before turning the power back
on again.
If the problem persists even after taking the above mentioned actions, contact your FUJITSU
scanner dealer or an authorized FUJITSU scanner service provider.
Scanner does not resume from standby mode.
■ Check item
After turning the scanner off, was the power turned back on again
immediately?
■ Action
Press the power button.
386
7.3 Other Troubleshooting