Fujitsu N7100 Operator's Manual page 102

3. Press the [OK] button.
 The information entered is set.
HINT
 If the IP address is the same as one already in use, network communication problems will
occur. In this case, try the following steps:
1. Disconnect the LAN cable.
2. Press the [Shutdown] button on the touch panel to turn the scanner off.
3. Press the power button to start the scanner with the LAN cable disconnected.
4. Enter a non-duplicated IP address.
5. Re-connect the LAN cable to the scanner.
 The connection with the scanner is lost if the IP address is changed via the Admin Tool. To
continue with other settings, close the Admin Tool and then access the scanner via the
Admin Tool again. If you access the scanner with an IP address, use the new IP address.
4.7 Configuring the Network Settings
102