I Want To Reset The Scanner To Factory Defaults; Data Cannot Be Scanned Properly - Fujitsu N7100 Operator's Manual

A "Scanner initialization has failed." message appears and the scanner
does not start up.
■ Check item
Is the status the same after the scanner is turned off and then turned back on
again?
■ Action
Disconnect the AC cable from the scanner to turn off the scanner, and connect the AC cable
again. After turning the power off, wait for at least 10 seconds before turning the power back on
again.
If the problem persists even after taking the above mentioned actions, contact your FUJITSU
scanner dealer or an authorized FUJITSU scanner service provider.

■ I Want to Reset the Scanner to Factory Defaults

I want to reset the scanner settings to their defaults.
■ Action
Refer to "Resetting to Factory Defaults" (page
I forgot the administrator login password.
■ Action
Contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.

■ Data Cannot Be Scanned Properly

Scanning does not start.
■ Check item
Has the document been loaded correctly into the ADF paper chute?
■ Action
Reload the documents into the ADF paper chute.
■ Check item
Is the LCD cover completely closed?
■ Action
Close the LCD cover completely.
174), and reset the scanner.
387
7.3 Other Troubleshooting