Chapter 6 Scanner Care - Fujitsu N7100 Operator's Manual

Chapter 6
Scanner Care
This chapter describes how to clean the scanner and replace parts in order to maintain
the scanner in optimum scanning condition.
WARNING
CAUTION
6.1 Cleaning Supplies and Parts to Clean .............................................................. 342
6.2 Cleaning the Exterior of the Scanner ................................................................ 344
6.3 Cleaning Inside the Scanner .............................................................................. 345
6.4 Cleaning a Carrier Sheet .................................................................................... 351
6.5 Replacing Parts ................................................................................................... 352
6.6 Performing a Scan Test ...................................................................................... 362
6.7 Calibrating the Touch Panel............................................................................... 365
Admin
Do not use any aerosol sprays or alcohol-based sprays to clean the
scanner. Dust blown up by strong air from the spray may enter the
inside of the scanner. This may cause the scanner to fail or
malfunction.
Sparks, caused by static electricity, generated when blowing off dust
and dirt from the outside of the scanner may cause a fire.
The glass inside the ADF can become hot when the scanner is used.
Before cleaning the inside of the scanner or replacing any parts, turn off
the power, unplug the power cable from the AC outlet, and wait for at
least 15 minutes.
Clean the feed rollers and eject rollers when the power is on.
Before replacing any parts, turn off the power, unplug the power cable
from the AC outlet, and wait for at least 15 minutes.
341
User