Function Key Programming Notes - Sam4s SPS-500 Series Program Reference Manual

Function Key Programming Notes

Cash Key Program Note
COIN CHANGER PORT# (0-4)
Enter the number of the serial port to which the coin changer is attached.
Check Key Program Note
COIN CHANGER PORT# (0-4)
Enter the number of the serial port to which the coin changer is attached.
Currency Conversion Key Program Notes
RATE
The value of foreign currency can be express in two ways: foreign currency in US dollars, and the
inverse, US dollars in foreign currency. For example a Canadian dollar may be worth $.70 US. The
inverse of that value statement would be that a US dollar is worth $1.428571 Canadian dollars. Look for
the rate expressed as US dollars in foreign currency (i.e. $1.428571 as in the example above) and enter
that value in this field. Note: this field can contain 8 digits, with the decimal in any position. For
example, you can enter 4 digits, the decimal, and four fractional digits.
CHANGE IN FOREIGN CURRENCY
Select whether any change from an over-tender is issued in foreign currency (Y) or home currency (N).
LINKED DRAWER # (0-3)
Select the drawer to be opened on foreign currency tender transactions.
Destination (1-10) Key Program Notes
KP PERIOD OVERRIDE (0=NO OVER)
Entry of a KP Group here allows kitchen printer routing based upon destination (Eat-in/Take-out/Drive
thru). Selection of a KP Group here would also override KP Time Period programs. Enter 0 for no
override.
KP Routing Key Program Note
ROUTING PERIOD IS
The KP ROUTING key is used to override KP Time Period control. For example, a restaurant might
normally operate two kitchens at one time and one kitchen at other times. In case the volume of business
changes, the manager might want to control the KP routing manually. Also, a single item, or large order
might be required to be sent to a different printer than normal. Select STAYDOWN, TRANS
(transaction), POP UP or ITEM POP up operation.
100  P Mode Programming
SPS-500 Program Manual v1.31