How To Access System Menu - Sam4s SPS-500 Series Program Reference Manual

How to Access System Menu

1. Turn the power switch located on the right side of the register to the OFF position.
2. Turn the control lock to the S position. (S is the unmarked position one position clockwise from the
PGM position.)
3. Press and hold the key position where the CASH key is located on the default keyboard layout.
7
4
1
0 00
4. Continue to hold the default CASH key location while turning the power switch to the ON position.
Hold the key until a short double-beep is heard.
5. Press the upper left key of the keyboard, then the lower left key, then the upper right key, and finally
press the lower right key.
6. There will be a short delay and the display will monitor a memory check. When complete, System
Password screen displays:
7. Touch 1 2 8 7. The System Menu screen displays.
SPS-500 Program Manual v1.31
8 9
TND1
5 6 CHECK
2 3 SBTL
.
CASH
1
2
TO ACCESS SYSTEM MENU
Press and hold this key position
during power-up in S Mode.
3
4
Software Installation & SD Utilities  27