Sam4s SPS-500 Series Program Reference Manual page 128

EDIT JOB CODES
Note: An employee with the appropriate authority level must be signed on to perform job code
programming.
Job codes are used to break down the hours worked for all employees into different categories (See
"Labor Groups" report in the Operation Manual.) A breakdown of hours by job is also reported for each
employee (See "Time Keeping" reports in the Operation Manual.)
The job codes to be used by all employees are set up here. There are 20 possible job codes. Each job
code you wish to activate must be given a descriptor here.
EDIT PAY RATES
Note: An employee with the appropriate authority level must be signed on to perform pay rate
programming.
All employees can use the pay rates set here. There are up to 50 pay rates.
DALLAS KEY LINK
This option is not currently available.
SALES AREA POSITION
This selection controls the location of the transaction area of the screen.
If LEFT: the 24-programmable locations are located at the left of the screen and the transaction display
area at the right of the screen.
If RIGHT, the 24-programmable locations are located at the right of the screen and the transaction display
area at the left of the screen.
128  P Mode Programming
SPS-500 Program Manual v1.31