Function Key Programming; Program 70 - Function Key Options - Sam4s ER-900 Series Operator's And Programming Manual

Function Key Programming

Three programs are used to program function keys:
In this chapter you will find:

Program 70 - Function Key Options

Use Program 70 to set options for function keys. Because of the differences inherent in
function keys, individual options will be different. See the specific instructions for each key
in this chapter to find the options for each key.
SAM4s ER-900 Series Operator's & Programming Manual v.1.39

Program 70 - is used to set individual options for each function key

Program 80 - is used to program an 18-character alphanumeric descriptor. In the
case of the #/No Sale key, provision is made to program a separate descriptor for
the # and No Sale functions.

Program 90 - is used to set a high amount limit (HALO). In the case of
percentage keys (%1-%5) the percentage rate or amount is programmed; In the
case of currency conversion keys, the conversion rate is programmed.

General instructions for programs 70, 80 and 90.

Specific Program 70 option programming instructions for each function key.
1. Turn the control lock to the PGM position.
2. To begin the program, enter 7 0, press the SUBTL key.
7 0 SUBTL
3. Enter the values for the option digit or digits. Depending on the function key
you are programming, you may enter up to six digits N1 through N6. Determine
the values for N1 through N6 by referring to the specific function key
information that follows. (You do not need to enter preceding zeros. For
example, if the function key offers six digits, N1 through N6 and you are only
selecting a value for N6, just enter the value for N6.) Press the function key you
wish to program.
N1 N2 N3
4. To program additional function keys, repeat from step 3, or press the CASH key
to finalize the program.
CASH
FUNCTION
N4 N5 N6
KEY
P-Mode Programming • 159