Sam4s SPS-500 Series Program Reference Manual page 28

Diagnostics/Functions Available form the System Menu
Display/Touch
SRAM
Loopback
Etc
RTC
Keyboard
Printer
SD
Check SMC Bad
Aging
28  Software Installation & SD Utilities
LCD
LCD Brightness
Touch
Rear Display
Rear LCD On/Off
LED On/Off
Read
Write
Printer Test
Cutter
Pattern Test
Reset Printer Count
Reset Cutter Count
Aging w/printer
Touch the screen to sequence through display test
patterns.
Display dims, and then brightens.
Indicates position activated when the screen is touched.
Initiates rear display test pattern. Touch any key or
screen to exit.
Flashes rear display backlight on/off. Touch any key or
screen to exit.
Flashes IRC LED. Touch any key or screen to exit.
Choose YES to test SRAM. Test clears memory.
Loop back connection required to complete test.
Displays test results for Nand Flash, SD card, MSR
track 1-3, MICOM version, displays cash drawer and
printer status.
Display current YYYY/MM/DD, time and day-of-week.
Set YYYY/MM/DD, time and day-of-week.
Display keyboard facsimile; indicates positions pressed.
Press lower-right key three times to end test.
Prints test receipt. Current receipt count displays on rear
display
Feeds, and then cuts paper. Touch any key or screen to
exit. Current cutter count displays on rear display.
Prints pattern test receipt.
Touch to reset printer count.
Touch to reset cutter count.
Insert SD card. Card is tested.
Performs NAND bad block test.
Starts continuous display/memory/printer test. Touch
SPS-500 Program Manual v1.31