Screen Saver Logo; Downloading Logo Images For The Internal Printer - Sam4s SPS-500 Series Program Reference Manual

Screen Saver Logo

When the screen saver is engaged, the default SAM4s logo moves in a pattern across the screen (this is the
FLOATING Logo). This logo can be replaced with a custom logo. Name the custom logo "logo.jpg". The
maximum logo size is 759 (wide) X 399
Set SYSTEM OPTION/GENERAL FUNCTION OPTION #58 to ROTATING to allow up to fifty images to
sequence on the screen. These images must be named "logo##.jpg" where ## is 01 through 50.
Follow these steps to implement a custom logo.
1. Make a "logo.jpg" file for a FLOATING logo or "logo##.jpg" files for ROTATING logos. NOTE:
File name must be lower case characters.
2. Make a folder on the SD card named \image. (This is the same folder that is used to contain key
images.)
3. Copy the logo files to this directory.
4. Move the SD card to the SPS-500.
5. From the SPS-500 S Mode menu, choose Key Relocation, Screen Designer, PGM Tab, then Image,
then Copy and confirm.
6. The new image(s) will replace the SAM4s logo as the screen saver.

Downloading Logo Images for the Internal Printer

You can load up to 14 images into SPS-500 memory through the SD card for printing on the internal printer.
Images files should be named logo_xx.bmp (where xx is 01-14). After loading, use P/SYSTEM
OPTONS/GENERAL PRINTING OPTIONS #34-37 to select the image number you wish to print on the
top/bottom of receipts and guest checks.
Note
Images must be in sequential order, beginning with logo_01.bmp. For example, you cannot load
logo_02.bmp without also loading logo_01.bmp at the same time. A "NOT FOUND" error will display if you
attempt to load logos that are not in a complete, sequential series.
Image Tips
 Maximum image sizes are:
o SPS-530 = 576 X 240 pixels
o SPS-520 = 384 X 240 pixels
 Images should be black & white
To Load Images
1. Prepare images in the proper sizes and with the proper file names (i.e. logo_01.bmp).
2. Copy images to the update/sps500 folder on the SD card. ((SD:\update\sps500\)
3. Access the System Menu (see "How to Access System Menu" on page 27.)
4. From the System Menu, touch Setup.
5. Touch Logo Define.
6. Insert the SD card.
7. Touch the Logo Def. SD to send the files from the SD card to the ECR.
SPS-500 Program Manual v1.31
(height). (logo.jpg works best if under 100K in size.)
Software Installation & SD Utilities  35