Fuji Xerox ApeosPort-V 7080 Administrator's Manual page 641

Setting Item Item Number
ESCP switch 60
(Paper feed
position)
61
(CR feature)
Position 15
adjustment (Vertical
position
adjustment)
16
(Horizontal
position
adjustment)
Escape sequence 62
(Escape
sequence)
63
(Escape
sequence
character)
Form overlay 64
Stapling 66
Bypass Tray - 67
Wait User
Sets the position to start printing at 8.5 mm or 22 mm below the top edge of
paper.
[0] (Default) : 8.5 mm
[1] : 22 mm
Sets the action to be executed when a CR command is received.
[0] (Default) : Carriage return
[1] : Carriage return and linefeed
Adjusts the printing position vertically or horizontally, and changes the
positions of the margins.
[0] (Default) : Off
[1-500] : -250 to +250 mm
Important • Data outside the printable area is not printed regardless of the
adjustment of the print position. In addition, data moved outside the
printable area as a result of adjusting the print position is not printed.
A normal extended command is specified starting with hexadecimal 1BH ESC
as the escape sequence identifying the command, followed by ; (3BH).
When you cannot use a semicolon or ESC code with the host computer, you
can use a special string instead as an escape sequence. This setting specifies
whether or not to enable the escape sequence replacement feature. When
enabling, specify the escape sequence with item 63.
[0] (Default) : Disabled
[1] : Enabled
For more information on extended commands, contact our Customer
Support Center.
To control an extended command with a text code, you must specify an
escape sequence (the first two bytes) of the extended command.
Enter two characters using the keyboard displayed on the screen.
[&%] (Default) : 0x21 - 0x7e
Constantly performs Form Overlay by selecting a form name (No. 01-64)
registered on the machine.
[0] (Default) : Off
[1-64] : No. 1 - No. 64
Important • Since the default value is selected for this feature, this setting is not
affected when an extended commend is received.
• Once a form name is selected, it continues to be displayed even if the
form is deleted. When a form name is selected using the up and down
arrow keys, it is not displayed. In this case, the setting is set to "Off".
Sets the stapling position.
[0] (Default) : Off
[1] : Top left
[2] : Top Double
[3] : Top Right
[4] : Left Double
[5] : Right Double
[6] : Bottom Left
[7] : Bottom Double
[8] : Bottom Right
Sets whether to suspend the print processing when feeding paper from the
bypass tray. Processing is resumed by a user operation on the machine.
[0] : Off
[1] (Default) : On
ESC/P-K Emulation
Value
16
641