Smb Client; Port 9100 - Fuji Xerox ApeosPort-V 7080 Administrator's Manual

Table of Contents

SMB Client

Select [Enabled] to use SMB when you use the Scan to PC (SMB) service or SMB

authentication service.

Select [Enabled] to use IPP.

Set this when you want to use IPP (Internet Printing Protocol) to print via the Internet.

Added Port Number

Select [Disabled] when you want to set the machine does not accept IPP from other than

the standard port number, or select [Enabled] when accepts all port numbers.

Enter a port number for IPP other than the standard port number from 1 to 65535.

The default value is 80.

Important • Do not use a number that is the same as a port number of another port. However, you can use the

Select [Enabled] to use Bonjour.

Select [Enabled] to use Port9100.

Select this option when the communication protocol is in the RAW format for Windows

Standard TCP/IP port monitor.

Enter a port number for Port9100 from 1 to 65535.

The default value is 9100.

Important • Do not use the numbers assigned to the other ports.

Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji

Xerox to control the machine on the network.

Select [Enabled] to use SIP, when you use IP fax (SIP) transmission.

same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,

WebDAV, and Web Services on Devices (WSD)).

• [Added Port Number] cannot be configured if [Port Status] is set to [Disabled].

To configure [Added Port Number], enable port status and reboot the machine, and then configure

[Added Port Number].

• To print from a printer detected by [Bonjour], the LPD port must be activated in advance.

Connectivity & Network Setup

Table of Contents