©
©
®
'jy z.
®
®
®
®
ASSEMBLY (CYLINDER HEAD)
Cylinder Head
1. Thoroughly remove all dirt, oil, or other material
from the top of the cylinder block.
2. Place the new cylinder head gasket in position.
3. Install the cylinder head.
4. Apply engine oil to the bolt threads and seat faces.
®
5. Tighten the cylinder head bolts in two or three steps
in the order shown in the figure.
Tightening torque:
80—86 Nm (8.2—8.8 m-kg, 59—64 ft-lb)
®
86U01X-147
Camshaft
1. Apply a liberal amount of engine oil to the journals
and bearings.
2. Place the camshaft in position with the dowel pin
facing straight up.
Camshaft Oil Seal
1. Apply liberal amount of clean engine oil to the cam
shaft oil seal and cylinder head.
2. Install the camshaft oil seal.
1B
1B—61