Knock Sensor; Oil Pressure Switch; Oil Cooler; Intake Manifold Assembly - Mazda 626 1989 Workshop Manual

ASSEMBLY (AUXILIARY PARTS) 1 1 *

Knock Sensor

install the knock sensor with the SST.
Tightening torque:
20—34 Nm (2.0—3.5 m-kg, 14—25 ft-lb)

Oil Pressure Switch

Install the oil pressure switch.
Tightening torque: 12—18 N-m
(1.2—1.8 m-kg, 104—156 in-lb)

Oil Cooler

Install the oil cooler.
Tightening torque:
29—39 N-m (3.0—4.0 m-kg, 22—29 ft-lb)
Oil Filter
1. Apply a small amount of engine oil to the rubber
seal of the new filter.
2. Install the oil filter and tighten it by hand until the
rubber seal contacts the base.
3. Then tighten the filter 1 and 1/6 turn with a wrench.

Intake Manifold Assembly

1. Place the new gasket in position.
2. Install the intake manifold assembly.
3. Tighten the nuts in two or three steps.
Tightening torque:
19—30 N-m (1.9—3.1 m-kg, 14—22 ft-lb)
Intake Manifold Bracket
Install the intake manifold bracket.
Tightening torque:
19—30 N-m (1.9—3.1 m-kg, 14—22 fMb)
86U01X-168