Stiffener - Mazda 626 1989 Workshop Manual

1B
ASSEMBLY (CYLINDER BLOCK)
1B—56
3. Apply engine oil to the oil seal lip.
4. Remove any dirt or other material from the con­
tact surfaces.
5. Apply a continuos bead of silicon sealant to the
contact surface of the oil pump.
Caution
Do not aliow any sealant to get into the oil
hole.
86U01X-133
6. Install a new O-ring into the pump body.
7. Install the oil pump.
Tightening torque
® : 19—25 N-m
(1.9—2.6 m-kg, 14—19 ft-lb)
®:
37—52 N-m
(3.8—5.3 m-kg, 27—38 ft-lb)
8. Remove any sealant which has been squeezed
out.
Oil Jet
Install the oil jet as shown in the figure.
Tightening torque: 12—18 N-m
(1.2—1.8 m-kg, 104—156 in-lb)
Caution
The shapes of the No.1,3 cylinders jet valves
and No.2, 4 jet valves are different.
76G01B-079

Stiffener

1. Remove any dirt of other material from the con­
tact surface.
2. Apply a continuous bead of silicon sealant to the
stiffener along the inside of the bolt holes, and over­
lap the ends.
3. Install the stiffener.
Tightening torque:
7—12 N-m (70—120 cm-kg, 61—104 in-lb)
76F01B-019