Mazda 626 1989 Workshop Manual page 198

N um ber 042/89
BEGINNING YIN OF PRODUCTION CHANGE
A. N o .l Engine Mount
For vehicles produced in Japan:
1989 626/M X -6
For vehicles produced in the U .S.A :
1989 M X -6
B. Radiator Lower Mount
For vehicles produced in Japan:
1989 626/M X -6
For vehicles produced in the U .S.A :
1989 M X -6
PARTS INFORM ATION
PART NUM BER
NEW
M 002 39 040A GJ23 39 040C
GJ28 39 040D GJ28 39 040B
F202 15 202B
F201 15 202A
B61A 15 202 F202 15 202B
REPAIR PROCEDURE
1. Check that the idle speed is within the specification:
Idle Speed: 750 ± 25 RPM (in P range)
If the idle speed is not within the specification, adjust it to 750 RPM with test connector grounded.
2. Replace the radiator lower mounts with the modified ones, if the vehicle was produced before the pro­
duction change.
3. Check that the radiator is centered in the ra­
diator upper brackets so that it can move
more effectively as a dynamic damper. If not,
adjust the radiator or the brackets as follows:
■ Adjust the position o f the upper brackets.
■ Adjust the position o f the radiator upper
hose so that the radiator is not pushed or
pulled out o f position.
Date Issued: 7/19/89
J M 1 G D * - * * * K1725513
1 Y V G D * * * # K5213922
J M 1 G D * * * * K1769601
1 Y V G D * -* * -* K 5245888
DESCRIPTION
OLD
N o .l Engine Mount
N o .l Engine Mount
Radiator Lower Mount
Radiator Lower Mount
Date Revised:
October 1, 1988
November 9, 1988
June 1, 1989
June 24.
INTERCHANGE
ABILITY
N E W —►OLD
N E W — OLD
N E W — OLD
N E W — OLD
Damper & Stud should
1 1
ii ii i' n . . ii 'n i r r n -n i i i r n
>89
APPLIED
MODEL
ATX w /o Turbo
ATX w/Turbo
ATX w /o Turbo
ATX w/Turbo
be centered.
Bracket
(with damper)
Radiator Stud
Page 2 of 3