p-T
COOLING FAN
S .-;-. ■
WATER THERMO SWITCH
1. Remove the cooling fan water thermo switch.
Note
Make sure that the ignition switch is OFF. I
not, the fan wifi operate when the connecto
is removed.
7 6 G 0 3 A - 0 1 3
2. Place the water thermo switch in water.
3. Heat the water gradually, and check for continu
ty of the switch with an ohm meter. Replace
necessary.
Water thermo switch (ON -► OFF):
97°C (207°F)....FE DOHC, FE 12-valve
91 °C (196°F)....F2, FE 8-valve, F8, F6
4. Install the water thermo switch and a new O-ring
Caution
Do not use sealing tape.