Show Enclosure-Status - HP P2000 G3 Cli Reference Manual

show enclosure-status

Description Deprecated; use
Shows the status of system enclosures and their components. For each attached enclosure, the
command shows general SCSI Enclosure Services (SES) information followed by component-specific
information.
Syntax
show enclosure-status
Output General SES fields:
Chassis
Chassis serial number.
Vendor
Enclosure vendor name.
Product ID
Product model identifier.
CPLD
Complex Programmable Logic Device version.
EMP # BUS:ID Rev
Address and firmware revision of the Enclosure Management Processor in each controller's
Expander Controller.
WWPN
World wide port name of the SES device reporting the enclosure status.
Status
Overall status of the enclosure:
• Absent: The enclosure is not present.
• Error: The enclosure has a fault.
• OK: The enclosure is operating normally.
Not Available: Status is not available.
Enclosure Component Status fields:
Type
Component type:
• FAN: Cooling fan unit.
• PSU: Power supply unit.
• Temp: Temperature sensor.
• Voltage: Voltage sensor.
• Disk: Disk drive module.
#
Component ID
Status
Component status:
• Absent: The component is not present.
• Error: The component or at least one subcomponent has failed.
• Warning: The component or at least one subcomponent is not working normally.
• OK: The component and any subcomponents are working normally. Temperature status OK
indicates that the sensor is working properly, not that the temperature is within an acceptable
range.
• N/A: Status is not available.
226 Alphabetical list of commands
show enclosures, show frus, or show sensor-status.