Set Job-Parameters - HP P2000 G3 Cli Reference Manual

set job-parameters

Description Sets parameters for background vdisk scrub, partner firmware upgrade, and other jobs.
Syntax
set job-parameters
[background-scrub enabled|disabled|on|off]
[partner-firmware-upgrade enabled|disabled|on|off]
[utility-priority low|medium|high]
Parameters background-scrub enabled|disabled|on|off
Optional. Sets whether disks in vdisks are automatically checked for disk defects to ensure system
health. The interval between background vdisk scrub finishing and starting again is 24 hours.
partner-firmware-upgrade enabled|disabled|on|off
Optional. Sets whether component firmware versions are monitored and will be automatically
updated on the partner controller.
• disabled or off: Partner firmware upgrade is disabled.
• enabled or on: Partner firmware upgrade is enabled. This is the default.
utility-priority low|medium|high
Optional. Sets the priority at which data-redundancy utilities, such as vdisk verify and reconstruct,
run with respect to I/O operations competing for the system's processors. (This does not affect vdisk
background scrub, which always runs at "background" priority.)
• high: Utilities have higher priority than host I/O. Use when your highest priority is to return the
system to a fully fault-tolerant state. This can cause heavy I/O to be slower than normal. This is
the default.
• medium: Utility performance is balanced with host I/O performance.
• low: Utilities run at a slower rate with minimal effect on host I/O. Use when streaming data
without interruption, such as for a web server, is more important than data redundancy.
Example Enable background scrubbing of vdisks and disable partner firmware upgrade:
# set job-parameters background-scrub on partner-firmware-upgrade off
Info: Parameter 'background-scrub' was set to 'on'. (2012-01-21 12:22:14)
Info: Parameter 'partner-firmware-upgrade' was set to 'off'. (2012-01-21
12:22:14)
Success: Command completed successfully. - The settings were changed
successfully. (2012-01-21 12:22:14)
See also • scrub vdisk
• set advanced-settings
• show job-parameters
160 Alphabetical list of commands