Verify Remote-Link - HP P2000 G3 Cli Reference Manual

verify remote-link

Description Verifies host-port links between the local system and a specified remote system. All link paths, or
only paths having a specified link type, between the two systems are tested. The remote system must
already have been added by using the
this tests the links to be used for replication from one system to another system. To verify
bidirectional communication, run this command from the primary system to the secondary system,
and then from the secondary system to the primary system.
Syntax
verify remote-link
remote-system system
[link-type FC|iSCSI|ALL]
Parameters remote-system system
The remote system's name or the IP address of one of its controller network ports.
link-type FC|iSCSI|ALL
Optional. Specifies the type of host-port links to verify:
• FC: Verify FC-to-FC links only.
• iSCSI: Verify iSCSI-to-iSCSI links only.
• ALL: Verify all FC-to-FC and iSCSI-to-iSCSI links.
If this parameter is omitted, all links are verified.
Output Port
Port ID on the local system.
Type
• FC: FC port.
• iSCSI: iSCSI port.
• Offline: Port is disconnected.
Links
IDs of linked ports on the remote system.
Example Verify all links between two 2-port, FC systems:
# verify remote-link remote-system System2
Port Type
---------------------------------------
A1 FC
A2 FC
B1 FC
B2 FC
---------------------------------------
Success: Command completed successfully. (2013-01-16 15:38:24)
Verify only iSCSI links between two 4-port, FC/iSCSI systems:
# verify remote-link remote-system System2 link-type iSCSI
Port Type
---------------------------------------
A3 iSCSI A3,A4,B3,B4
A4 iSCSI A3,A4,B3,B4
B3 iSCSI A3,A4,B3,B4
B4 iSCSI A3,A4,B3,B4
---------------------------------------
Success: Command completed successfully. (2013-01-16 15:38:24)
Links
A1,A2,B1,B2
A1,A2,B1,B2
A1,A2,B1,B2
A1,A2,B1,B2
Links
create remote-system command.For replication purposes,
HP P2000 G3 MSA System CLI Reference Guide 339