Show Volume-Maps - HP P2000 G3 Cli Reference Manual

show volume-maps

Description Shows mapping information for a specified volume or for all volumes.
Syntax
show volume-maps [volume]
Parameters volume
Optional. Name or serial number of the volume to show mappings for. For volume syntax, see
Command syntax
Output Serial Number
Volume serial number.
Name
Volume name.
Ports
• Controller host ports that the mapping applies to.
• Blank if not mapped or mapped as no-access.
LUN
• LUN that identifies the volume to a host.
• Blank if not mapped or mapped as no-access.
Access
Type of host access to the volume:
• read-write: The host has read and write access to the volume. This is the default.
• read-only: The host has read access to the volume.
• no-access: The host is denied access to the volume.
• not-mapped: The host is not mapped to the volume.
Host-Port-Identifier
• FC and SAS: Host WWPN.
• iSCSI: Host initiator node name (typically the IQN).
• all other hosts for the volume's default mapping.
Nickname
Host nickname, or blank if not set or for all other hosts.
Profile
• Standard: The host allows LUN 0 to be assigned to a mapping.
• OpenVMS: The host does not allow LUN 0 to be assigned to a mapping.
• HP-UX: The host allows LUN 0 to be assigned to a mapping and uses Flat Space Addressing.
on page 22. If this parameter is omitted, information for all volumes is shown.
HP P2000 G3 MSA System CLI Reference Guide 317