Show Ports - HP P2000 G3 Cli Reference Manual

show ports

Description Shows information about host ports on both controllers. This command shows the same information
as the show host-parameters
Syntax
show ports
Output Ports
Controller ID and port number.
Media
• FC(P): Fibre Channel Point-to-Point (public or private).
• FC(L): Fibre Channel-Arbitrated Loop.
• FC(-): Not applicable, as when the port is disconnected.
• SAS: Serial Attached SCSI.
• iSCSI: Internet SCSI.
Target ID
Port WWN or IQN.
Status
Whether the port is operational, has a problem, or is disconnected.
Speed (A)
Actual host-port link speed, or blank if not applicable.
Speed (C)
Configured host-port link speed:
• FC: Auto, 8Gb, 4Gb, or 2Gb (Gbit/sec).
• iSCSI: Auto or 1Gb (Gbit/sec).
• Blank if not applicable.
Health
•
OK
•
Degraded
•
Fault
•
N/A
Health Reason
If Health is not OK, this field shows the reason for the health state.
Health Recommendation
If Health is not OK, this field shows recommended actions to take to resolve the health issue.
Topo (C)
FC and SAS only. Configured topology.
Width
SAS only. Number of PHY lanes in the SAS port.
PID
FC only. Primary loop ID, or blank if not applicable.
IP-Ver
iSCSI only. IP version: IPv4 or IPv6.
PIP
iSCSI only. Primary IP address.
PIP-Gateway
iSCSI only. Primary gateway IP address.
command.
HP P2000 G3 MSA System CLI Reference Guide 257