Show System-Parameters - HP P2000 G3 Cli Reference Manual

show system-parameters

Description Shows the current settings for the storage system.
Syntax
show system-parameters
Output ULP Enabled
Shows that the system is using Unified LUN Presentation, which can expose all LUNs through all host
ports on both controllers. The interconnect information is managed in the controller firmware. ULP
appears to the host as an active-active storage system where the host can choose any available path
to access a LUN regardless of vdisk ownership. When ULP is in use, the system's
operating/cache-redundancy mode is shown as Active-Active ULP. ULP uses the T10 Technical
Committee of INCITS Asymmetric Logical Unit Access (ALUA) extensions, in SPC-3, to negotiate
paths with aware host systems. Unaware host systems see all paths as being equal.
Host Profiles Enabled
Shows whether host profiles are enabled, which determines whether LUN 0 can be assigned to
volume mappings.
Number of Host Ports
Number of host-interface ports in the controller enclosure.
Maximum Disks
Number of disks that the system supports.
Maximum Volumes
Number of volumes that the system supports.
Maximum Vdisks
Number of vdisks that the system supports.
Maximum LUNs
Number of LUNs that the system supports.
Maximum Vdisks Per Controller
Number of vdisks that each controller supports.
Local Controller
ID of the controller you are accessing.
Serial Number
Last six digits of the midplane serial number.
Example Show current settings for the storage system:
# show system-parameters
System Parameters
-----------------
ULP Enabled: true
Host Profiles Enabled: true
Number of Host Ports: value
Maximum Disks: value
Maximum Volumes: value
Maximum Vdisks: value
Maximum LUNs: value
Maximum Vdisks Per Controller: value
Local Controller: A
Serial Number: SN
Success: Command completed successfully. (2012-01-19 15:28:32)
Basetypes • system-parameters-table
• status
HP P2000 G3 MSA System CLI Reference Guide 293