Set Priorities - HP P2000 G3 Cli Reference Manual

set priorities

Description Sets snapshot-retention priorities for a specified snap pool. Snap-pool priorities, in conjunction with
snapshot priorities, determine which snapshots are retained if system resource limitations require
some snapshots to be automatically deleted.
Lower-priority snapshots will be deleted before higher-priority snapshots. Priority values are
1–65535. To use a default priority, specify the value 0.
Syntax
set priorities
[standard-snap #]
[volume-copy #]
[replication-snap #]
[replicating #]
[common-sync-point #]
[only-sync-point #]
[queued #]
snap-pool
Parameters standard-snap #
Optional. Retention priority for a standard snapshot. The default is 0x6000 (24576).
volume-copy #
Optional. Retention priority for a snapshot that is being used to copy data from a source volume to a
destination volume. This attribute is temporary for the duration of the volume-copy process. The
default is 0xa000 (40960).
replication-snap #
Optional. Retention priority for a replication snapshot. The default is 0x4000 (16384).
replicating #
Optional. Retention priority for a snapshot that is being replicated to a secondary volume. This
snapshot is required in order to resume the replication. The attribute is temporary for the duration of
the replication process. The default is 0xc000 (49152).
common-sync-point #
Optional. Retention priority for the latest snapshot that is copy complete on all secondary volumes. It
identifies a common point in time that is known by all destinations. The default is 0x8000 (32768).
only-sync-point #
Optional. Retention priority for the only sync point that is available on at least one secondary
volume. If this snapshot is removed, then the next replication requires a full sync to be performed. The
default is 0xe000 (57344).
queued #
Optional. Retention priority for a snapshot that was taken for remote replication but is queued
waiting for the previous replications to complete. The default is 0x2000 (8192).
snap-pool
Name or serial number of the snap pool.
Example Set attribute priorities for snap pool SP1, raising the priority for standard snapshots and leaving
other priorities unchanged:
# set priorities only-sync-point 65535 SP1
Success: Command completed successfully. - The priorities were successfully set.
(2012-01-21 12:28:24)
See also • show priorities
• show snap-pools
HP P2000 G3 MSA System CLI Reference Guide 167