HP P2000 G3 Cli Reference Manual page 460

Table 67 sas-status-controller-a properties (continued)
Name
elem-status
elem-status-
numeric
elem-disabled
elem-disabled-
numeric
elem-reason
460 XML API basetype properties
Type Description
The SES status that corresponds to the PHY status.
string
• Disabled: Critical condition is detected.
• Error: Unrecoverable condition is detected. Appears only if there is a
firmware problem related to PHY definition data.
• OK: Element is installed and no error conditions are known.
• Non-critical: Non-critical condition is detected.
• Not Used: Element is not installed in enclosure.
• Unknown: Either:
• Sensor has failed or element status is not available. Appears only if an
I/O module indicates it has fewer PHYs than the reporting I/O module,
in which case all additional PHYs are reported as unknown.
• Element is installed with no known errors, but the element has not been
turned on or set into operation.
Numeric equivalents for elem-status values.
string
•
0: Error
•
1: OK
•
2: Disabled
•
3: Non-critical
•
4: Error
•
5: Not Used
•
6: Unknown
•
7: Unknown
•
8: Unknown
• Enabled: PHY is enabled.
string
• Disabled: PHY is disabled.
Numeric equivalents for elem-disabled values.
string
•
0: Enabled
•
1: Disabled
More information about the status value.
string
• Blank if elem-status is OK.
• Error count interrupts: PHY disabled because of error-count
interrupts.
• Externally disabled: PHY disabled externally via serial debug port.
• PHY control: PHY disabled by a SES control page as a result of action by
a Storage Controller or user.
• Not ready: PHY is enabled but not ready. Appears for SC- 1 PHYs when
the partner I/O module is not installed. Appears for Drive, SC- 1 , or Ingress
PHYs when a connection problem exists such as a broken connector.
• Drive removed: PHY disabled because drive slot is empty.
• Unused - disabled by default: PHY is disabled by default because
it is not used.
• Excessive PHY changes: PHY is disabled because of excessive PHY
change counts.