Error Messages; Verifying And Updating Enclosure Firmware Offline; Verifying The Enclosure Firmware - HP Smart Array -UX 11i v2 Support Manual

Error messages

The following error messages might appear when using saupdate:
When keyword LIST or UPDATE is misspelled or extra parameters are specified:
Error: Syntax Error
Usage: saupdate LIST or saupdate UPDATE [ | all ]
When the controller ID in the saupdate UPDATE command is not correct:
No matching controller found
When a firmware file does not exist in the saupdate UPDATE directory:
INCPTR.BIN does not exist.
File INCPTR.BIN: Not Found
When an invalid or corrupted firmware file is specified in the saupdate UPDATE command:
INCPTR.BIN does not exist.
File INCPTR.BIN: invalid or corrupted

Verifying and updating enclosure firmware offline

To verify and update the firmware in an external enclosure, follow the procedures in this section.
After initial installation, you can verify and update the enclosure firmware online using sautil.
See "Checking and updating SAS storage enclosure firmware online" (page

Verifying the enclosure firmware

To verify the firmware image on the enclosure, use saupdate from the EFI Shell.
To verify the enclosure firmware with saupdate:
1. Prepare to run saupdate from the Offline Diagnostics CD or the EFI partition:
To run saupdate from the Offline Diagnostic CD:
a.
b.
c.
d.
To run saupdate from the EFI partition:
a.
b.
c.
30 Installing the controller
Place the Offline Diagnostic CD containing saupdate.efi in the CD drive before
booting the system.
Boot the system to the EFI Shell prompt.
Locate the cdrom entry in the list of mapped devices, and change to the device by
entering its associated fs number (for example, fs0) at the EFI Shell prompt.
If the EFI utility is not located in the root directory, move to the directory where the
file is located, for example:
fs0:\> cd \EFI\HP\TOOLS\IO_CARDS\SmartArray
Download the SA EFI update utility saupdate.efi and copy it to the EFI partition.
Boot the system to the EFI Shell and change directories to the EFI partition.
If the EFI utility is not located in the root directory, move to the directory where the
file is located, for example:
fs0:\> cd \EFI\HP\TOOLS\IO_CARDS\SmartArray
82).