Set Advanced-Settings - HP P2000 G3 Cli Reference Manual

set advanced-settings

Description Sets advanced system configuration options.
Syntax
set advanced-settings
[auto-write-back enabled|disabled|on|off]
[background-disk-scrub enabled|disabled|on|off]
[background-scrub enabled|disabled|on|off]
[background-scrub-interval interval]
[compact-flash-failure enabled|disabled|on|off]
[controller-failure enabled|disabled|on|off]
[dynamic-spares enabled|disabled|on|off]
[emp-poll-rate rate]
[fan-failure enabled|disabled|on|off]
[host-cache-control enabled|disabled|on|off]
[independent-cache enabled|disabled|on|off]
[managed-logs enabled|disabled|on|off]
[missing-lun-response notready|illegal]
[partner-firmware-upgrade enabled|disabled|on|off]
[partner-notify enabled|disabled|on|off]
[power-supply-failure enabled|disabled|on|off]
[smart enabled|disabled|on|off|detect-only]
[super-cap-failure enabled|disabled|on|off]
[sync-cache-mode immediate|flush]
[temperature-exceeded enabled|disabled|on|off]
[utility-priority low|medium|high]
[spin-down enabled|disabled|on|off]
[spin-down-delay delay]
[single-controller]
Parameters auto-write-back enabled|disabled|on|off
Optional. Sets whether the cache mode will change from write-through to write-back when the
trigger condition is cleared.
• disabled or off: Auto-write-back is disabled.
enabled or on: Auto-write-back is enabled. This is the default.
•
background-disk-scrub enabled|disabled|on|off
Optional. Sets whether disks that are not in vdisks are automatically checked for disk defects to
ensure system health. Background disk scrub will start 72 hours after it is enabled. The interval
between background disk scrub finishing and starting again is 72 hours.
• disabled or off: Background disk scrub is disabled. This is the default.
enabled or on: Background disk scrub is enabled.
•
background-scrub enabled|disabled|on|off
Optional. Sets whether disks in vdisks are automatically checked for disk defects to ensure system
health. The interval between background vdisk scrub finishing and starting again is specified by the
background-scrub-interval parameter.
• disabled or off: Background vdisk scrub is disabled.
• enabled or on: Background vdisk scrub is enabled. This is the default.
background-scrub-interval interval
Optional. Sets the interval in hours between background vdisk scrub finishing and starting again,
from 1–360 hours. The default is 24 hours.
HP P2000 G3 MSA System CLI Reference Guide 133