HP P2000 G3 Cli Reference Manual page 335

Continuing the previous example, you decide to re-enable trust and proceed by specifying the
unsafe parameter.
# trust enable
Success: Command completed successfully. - Trust is enabled. (2013-09-17
09:06:48)
# trust vdisk VD1 unsafe
Location Serial Number
-----------------------------------------------------------------------------
1.2
1.4
1.5
-----------------------------------------------------------------------------
WARNING: Found out-of-sync disk(s). Using these disks for trust will in most
cases cause data corruption.
Because of the risk of data corruption, it is recommended that you continue the
trust operation only with the supervision of Support personnel. If you are ready
to continue, enter "continue" at the prompt or enter "abort" to abort the
operation and leave the vdisk offline.
> continue
If you continue with the trust operation, you risk corrupting data in this
vdisk. Enter "accept" at the prompt if you intend to accept this risk and
proceed with the trust operation or enter "abort" to abort the operation and
leave the vdisk offline.
> accept
Success: Command completed successfully. (VD1) - Trust operation completed
successfully for this vdisk. (2013-09-17 09:07:31)
Abort an unsafe trust operation when you decide not to risk using bad disks.
# trust enable
Success: Command completed successfully. - Trust is enabled. (2013-09-17
09:05:37)
# trust vdisk vdr5
Location Serial Number
-----------------------------------------------------------------------------
1.2 SN
1.4 SN
1.5 SN
-----------------------------------------------------------------------------
WARNING: * Found out-of-sync disk(s). Using these disks for trust will in most
cases cause data corruption.
Because of the risk of data corruption, it is recommended that you continue the
trust operation only with the supervision of Support personnel. If you are ready
to continue, enter "continue" at the prompt or enter "abort" to abort the
operation and leave the vdisk offline.
> continue
If you continue with the trust operation, you risk corrupting data in this
vdisk. Enter "accept" at the prompt if you intend to accept this risk and
proceed with the trust operation or enter "abort" to abort the operation and
leave the vdisk offline.
> abort
Error: Command was aborted by user. (2013-09-17 09:05:49)
After enabling trust, disable it if you decide not to run trust vdisk:
# trust disable
Success: Command completed successfully. - Trust is disabled. (2013-09-17
17:40:01)
Basetypes • status
See also • show vdisks
• verify vdisk
Type State
SN SAS LEFTOVR False
SN SAS VDISK
SN SAS LEFTOVR True
Type State
SAS LEFTOVR False
SAS VDISK
SAS LEFTOVR True
Partially Reconstructed
False
Partially Reconstructed
False
HP P2000 G3 MSA System CLI Reference Guide 335
Out Of Sync Age
True 6
False 7
False 4
Out Of Sync Age
True 6
False 7
False 4