Show Replication-Sets - HP P2000 G3 Cli Reference Manual

show replication-sets

Description Shows information about replication sets on the local system. You can view information about all
replication sets or a specific replication set.
Syntax
show replication-sets [replication-set]
Parameters replication-set
Optional. Name or serial number of a replication set or volume for which to display
replication-set-level information. If this parameter is omitted, information is shown for all replication
sets.
Output Replication set information:
Name
Replication set name.
Serial Number
Replication set serial number.
Replication volume information:
Name
Replication volume name.
Serial Number
Replication volume serial number.
Status
Replication volume status: Replicating, Suspended, Initializing, Inconsistent,
Offline, Online, or Establishing proxy. After a secondary volume is reattached it has
Establishing proxy status while establishing a proxy connection with the remote (primary)
system in preparation for replication.
Status-Reason
More information about the status value, or N/A for Online status.
Monitor
Replication volume monitoring status:
• OK: Communication to the remote volume is successfully occurring on the FC or iSCSI network.
• Failed: Communication to the remote volume has failed because of an FC or iSCSI network
issue or because the remote volume has gone offline.
Location
Replication volume location: Local or Remote.
Primary-Volume
Primary volume name. If the replication set has a primary-volume conflict, all associated primary
volumes are displayed.
Primary-Volume-Serial
Primary volume serial number. If the replication set has a primary-volume conflict, all associated
primary volumes are displayed.
Primary-Volume-Status
Primary volume status: Online, Offline, Conflict, or N/A.
MaxQueue
Number of replication images to consider when determining the next image to replicate. Used only
if the On Collision parameter is set to Oldest.
MaxRetryTime
Amount of time in seconds that the replication volume should retry a replication operation on any
specific image when errors occur. Used only if the On Error parameter is set to Retry.
270 Alphabetical list of commands