Show Ports - HP P2000 G3 Cli Reference Manual

Show port information for a system with two iSCSI ports:
# show host-parameters
Ports Media
Health Reason
-----------------------------------------------------------------------------
A1 iSCSI
IP-Ver PIP
--------------------------------------------------------------
IPv4
A2 iSCSI
There is no host connection to this host port.
IP-Ver PIP
--------------------------------------------------------------
IPv4
------------------------------------------------------------------------------
Success: Command completed successfully. (2012-01-18 15:03:55)
Show port information for a system with two SAS ports:
# show host-parameters
Ports Media
Health Reason
-----------------------------------------------------------------------------
A1 SAS
Topo(C) Width
--------------
Direct
A2 SAS
There is no host connection to this host port.
Topo(C) Width
--------------
Direct
-----------------------------------------------------------------------------
Success: Command completed successfully. (2012-01-18 15:04:10)
Basetypes • port
• status
See also • set host-parameters

• show ports

242 Alphabetical list of commands
Target ID
IQN
PIP-Gateway PIP-Netmask MAC
10.134.9.100 10.134.0.1
IQN
PIP-Gateway PIP-Netmask MAC
10.134.9.101 10.134.0.1
Target ID
WWPN
4
WWPN
4
Status Speed(A) Speed(C)
Health Recommendation
Up 1Gb
255.255.0.0 00:C0:FF:29:00:24
Disconnected
- No action is required.
255.255.0.0 00:C0:FF:29:00:23
Status Speed(A)
Health Recommendation
Up Auto
Disconnected Auto
- No action is required.
Health
Auto OK
Auto N/A
Health
OK
N/A