Connecting The Receiver - Ko Propo Esprit-3 Universe Instruction Manual

Be certain to use only KO Propo
Warning!
genuine FM crystal sets(transmitter
Execution
and receiver). Never use crystals
produced by other companies since
such crystals may vary in frequency,
which could lead to misoperation or
out of control use.
Be sure to connect all equipment
Warning!
correctly. If connections are loosened
Execution
by vibration,the model may run out of
control.
Do not cut or bundle the aerial wire
Warning!
with other cords. It may result in
Prohibition
decreasing the sensitivity of the
receiver and may result in the model
running out of control.
Be careful not to reverse the polarity
Caution!
Caution!
of the transmitter and the receiver.
Prohibition
Reverse polarity could damage the
units.
Be sure to use genuine KO Propo
Caution!
Caution!
products e.g. transmitter,receiver,
Execution
ESC and other optional parts.
We cannot assume any
responsibility for the use of other
companies products with this unit.
Be sure to use grommets and be
Warning!
sure that the servo is not touching
Execution
any metal plates directly.
The vibrations may damage
the servo and the model may
run out of control.

Connecting the Receiver

Connecting the receiver
KR-302F
Antenna Lead
BATT
Switch Harness
CH1
Steering Servo
CH2
ESC or Throttle Servo
For an electric-powered car
Receiver
ESC
(Electric
Speed
Controler)
For a gasoline-powered car (6V servos)
5N600mAh
6VNicd Battery
Receiver
For a gasoline-powered car
6N600mAh
7.2VNicd Battery
7V Reguletor
Switch Harness
Receiver
Crystal
replacement
ESC
CH3
(ESC + 6V servos)
Steering Servo
Switch Harness
Throttle Servo
Steering Servo
(7.2V FET Servos)
Throttle
Servo
Steering
Servo