Response Adjust - Ko Propo Esprit-3 Universe Instruction Manual

ULTRA (Ultra high-speed response mode.)
This operation speed is suitable when the super module of the Helios is installed.
The response transcends that of the EX-10 Helios using the RF-502FH super module.
Requires the use of the receiver and servo to match that of the advanced high-speed
response.
About channel select
ADVANCED (Advanced high-speed response mode.)
This operational speed is the same as the Helios normal module.
From the function menu the "RESPONS" will need to be set to "ADVANCED" and the "CH.
SELECT" will need to be set to "2CH".
This response exceeds that of the Vantage type R.
Requires the use of the receiver and servo to match that of the advanced high-speed
response.
About channel select
SUPER (Super high-speed response mode.)
This operational speed is the same as that of the Vantage type R.
From the function menu the "RESPONS" will need to be set to "SUPER".
In this case the number of channels, which are set in the "CH.SELECT", does not influence
the speed.
Requires the use of the receiver and servo to match that of the super high-speed
response.
NORMAL (Normal speed response mode.)
This operational speed is the same as that of the Vantage.
From the function menu the "RESPONS" will need to be set to "NOMAL".
In this case the number of channels, which are set in the "CH.SELECT", does not influence
the speed.
All of our receivers and servo can be used.
[How to setup the response]
The use of ULTRA and ADVANCED high-speed response modes exclusively can only use
the 2CH mode due to the limit of the speed of the radio wave.
Please note, even if the indication on the screen is "ULTRA" or "ADVANCED", radio wave
speed becomes SUPER high-speed response mode when you set it to "3CH".
RESPONS (Response)
Using the Jog Dial, (+) or (-) keys, select the function
"RESPONS" and press the 'ENTER' key.
Using the Jog Dial, (+) or (-) keys, select the
response mode.
Pressing the 'ENTER' key will return you to the function
menu.
1