Throttle Brake - Ko Propo Esprit-3 Universe Instruction Manual

Only the operating range of the brake side of the throttle is adjusted.
Throttle operation of the brake side can be increased and decreased in range. The maximum brake quantity can be
changed.
[How to open the setup screen]
From the initial screen, use the Jog Dial, (+) or (-) keys to open the function menu.
Using the Jog Dial, (+) or (-) keys move the cursor in the menu list to "TH:BRAKE".
Press the 'ENTER' key to enter the setting screen.
In a gas car, if a large value is set, the end point may not be correct and excessive duty may be applied
to the servo. This will cause the servo to consume excessive voltage and possibly damage the servo.
Please verify your setting and adjust it accordingly.
In an electric car, a value set too small will not be effective and may not be recognized by the ESC.
Please use the setting of 100 (factory default).
Assigning this function to be adjusted, as a percentage being used with an ET lever is possible. (ET-4
is assigned as the factory default.) Please note that a brake setting of 0 will not yield any movement.
When the function is assigned to an ET lever, the setting is indicated automatically (automatic display)
when the lever is pressed.
Please note that when the percentage being used is set to 0%,
no brake movement will be yielded even if the brake setting is set to a large number.
When assigning this function other then the ET-4 (factory default), please refer to the SET
UP (P58 setup).
TH BRAKE (Throttle Brake)
When operating the throttle,
you adjust the operating
movement of the servo.